Refilling Water - Ruby Fires MF1520C Mode D'emploi

4. If there is no satisfactory socket near the selected position, please ask a professional electrician
to install the socket behind or near the frame as per requirement.
WARNING
Do not install an electric circuit or socket arbitrarily in order to prevent fire accidents, elec-
tric shock or physical injury. Please ask a professional electrician to install the circuit.
1. Turn off the switch on the core of the fireplace.
2. Insert the power plug into AC230V/15A socket. The cable should be laid along the wall.
3. Pull the core of fireplace into the frame or the wall structure until it parallels with the panel or
wall.
4. Finish the installation ensuring that the power plug is accessible after installation.
5. Level the fire by adjusting the feet.
Note
If necessary, the profiles on the side of the unit can be easily removed by removing the two
screws.

REFILLING WATER

1. When there is no mist, or you hear the water shortage alarm, please refill the water tank imme-
diately.
2. When the water no longer covers the atomization sheet, atomization stops in 3 seconds and
there will be no flame effect.
3. When the atomizer stops, please turn all controls off, unplug the appliance, refill the water tank,
plug back in and restart.
4. Fill Water Tank with tap water only. Distilled water must not be used.
A. Take off the log set. Keep in mind that the log-piece has to be removed by holding it with both
hands, lifting the right side before lifting it up as a whole. When placing it back, place the left side
first and then the right side. Water may leak out of the log set.
5