Cycle And Option Descriptions - Jenn-Air JDD4000AWS2 Instructions D'utilisation

Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired. To
Cancel an option, press it again.
Start or Resume a Cycle
■ Prior to starting the dishwasher, turn the hot
water on at the sink next to the dishwasher. Let
the water run until it is hot. This ensures that hot
water will enter the dishwasher when it is
started. Make sure to turn the sink water off.
This information covers several different models. Your dishwasher may not have all of the cycles and options described.
CYCLE SELECTIONS
CYCLES DISH LOAD TYPES
Use for loads with normal
amounts of food soil.
Use for hard-to-clean, heavily
soiled pots, pans, casseroles,
and regular tableware.
Use for loads with normal
amounts of food soil.
Use for lightly soiled items or
china and crystal.
Use to quickly wash
prerinsed glasses or dish
loads.
Use for rinsing dishes,
glasses and silverware that
will not be washed right away.
You can customize your cycle by selecting an option.
See option selections. If you change your mind, press the option again to turn off the option, or select a different option. You can change
an option anytime before the selected option begins.
*Maximum wash times depend on water temperature, heavy soil condition, dish load size and options selected.
NOTE: Drying time (fan running) is typically 4 hours after wash cycle. After 30 minutes of dry time, the clean light will illuminate. Anytime
after the clean light is lit and the drawer is opened for longer than 30 seconds, the cycle will be terminated.
4
STEP 4

Cycle and Option Descriptions

DESCRIPTIONS
This cycle uses a sensor to adjust
amount of water, time and heat.
This cycle forces maximum time, water
and heat.
The energy-usage label is based on this
cycle.
This cycle washes at lower temperatures.
Towel drying may be required.
This cycle does not dry.
This cycle does not dry.
Do not use detergent.
■
Select the wash cycle and options desired.
■ Press START/RESUME button once and close the drawer. After
a brief pause, the cycle will begin. The drawer must be closed
within 4 seconds after pushing START/RESUME or the lights
will flash, a tone will sound, and the dishwasher will not begin.
Press the START/RESUME button again and shut the drawer
within 4 seconds.
■
You can add an item anytime before the main wash starts.
Open the drawer slowly and add the item. Press the START/
RESUME then close the drawer.
NOTE: If you have a 2-drawer dishwasher model, each drawer has
its own controls and can run independently of the other.
Cycle
Minimum
1:15
1:30
1:05
1:00
0:30
0:10
WASH TIME (HH:MM)
Cycle + Options *Maximum
Minimum
1:30 2:10
1:30 2:10
1:30 2:10
1:00 1:20
none none
none none