Care And Maintenance - Heath Zenith LED DualBrite Instructions D'installation Et Mode D'emploi

Operating Modes
Mode: On-Time
Test
5 Seconds
Auto
1, 5, or 10 Minutes
Accent
3, 6 Hour, To Dawn
Manual
To Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
• Motion Sensor (AUTO) – This light fixture is designed
to automatically turn on when the sensor detects a tem-
perature difference moving across the front of the motion
sensor. The light will turn off automatically after a set
amount of time. The ON-TIME control should be set
to 1, 5, or 10 minute setting and the wall switch should
be left in the ON position at all times.
• Optional DualBrite® Control – This optional feature
allows the light fixture to turn on at a lower light level
after dusk (sunset) for the amount of time selected. When
motion is detected, the lights will turn on full bright. This
feature can be turned OFF and the motion sensor will
continue to work in AUTO mode.
Works: Day Night
x x
x
x
x
/ minutes for
1
2
• Manual Mode – Manual mode overrides the motion sen-
sor and "ON-TIME" control so the light will operate full
bright. This feature only works at night and only for one
night at a time. The motion sensor will reset to motion
sensing mode after 6 hours or sunrise, whichever comes
first. Manual mode can be toggled on and off using a wall
switch. Note: If the power to the light fixture is off for
more than 5 seconds, allow the motion sensor to warm
up prior to switching to manual mode.
1. Ensure the power to the light is ON and the sensor
has warmed up (60 seconds).
2. To turn manual mode on, switch the power OFF–ON–
OFF–ON at the wall switch within 5 seconds.
3. To turn manual mode off, switch the power OFF–ON–
OFF–ON at the wall switch within 5 seconds.
OFF ON
Less than 5 seconds
IMPORTANT: If manual mode does not turn ON or OFF,
use a slower pace turning the power ON and OFF at the
wall switch while staying within 5 seconds.

CARE AND MAINTENANCE

• To prolong the original appearance, clean with clear water
and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light fixture. They could cause a premature deterioration
of the finish. This is not a defect in the finish and will not
be covered by the warranty.
• Do not spray with hose or power washer.
6
OFF ON