Control Panel; On / Off; Child Lock - Rinnai EnergySaver ES38 Manuel D'installation Et D'utilisation

Control Panel

Control Panel
Timer 1
Override
Sensible Temperature Control
The sensible temperature control feature allows
comfortable heating which matches the conditions in
the room.
Based on the information collected by the room
temperature thermistor when the heating starts, the
heating capacity is automatically adjusted to achieve a
Filter Lamp
If the filter lamp flashes during operation, check the air filter for dust. If dust is
present, clean the filter. See the Care and Maintenance section. Turn the heater off
before cleaning the filter.

On / Off

When you press and release the ON/OFF button, the Temperature Level lamps will illuminate,
the combustion fan will begin to run, and the spark will ignite the main burner.
This heater has an automatic ignition system. When the main burner has lit, the combustion
lamp will glow red, and the spark will stop.
If ignition does not occur, the appliance will automatically turn off and the Temperature Level
lamps will flash indicating a fault code. This may occur when using the appliance for the first time
or if it has not been used for a while. Try operating the appliance again.
To turn the heater off, press the ON/OFF button. The fan will continue to operate for several
minutes after the burner has gone out in order to cool the heater. Do not unplug the heater while
the fan is running.

Child Lock

This feature locks the buttons to prevent unintended operation.
Press the up and down buttons to activate and the lamp will glow. Pressing and
holding the up and down buttons for two seconds will disengage the Lock.
If the Lock is engaged while the unit is operating, all buttons will be disabled except
for the ON/OFF button.
If the Lock is engaged while the unit is off, then all buttons will be disabled. The
Lock must be disengaged in order to turn the unit on.
AM
Timer 2
P M
Set
Economy
Rinnai Corporation ES38 Manual
Clock
Timer 1
Timer 2
Room
Temp
Set Times
Time
Child Lock
comfortable heating effect and to reach the
temperature setting quickly.
Occasionally, the room temperature may briefly exceed
the temperature setting due to the layout of the room or
heating area.
Set back
ff
on o
ON /OFF
Filter
ON /OFF
Temp
Time
Child Lock
ON
7