Operating Instructions; To Turn Off Gas To Appliance - Rinnai EnergySaver ES38 Manuel D'installation Et D'utilisation

Operating Instructions

FOR YOUR SAFETY READ BEFORE OPERATING
WARNING
A. This appliance does not have a pilot. It is
equipped with an ignition device which
automatically lights the burner. Do not try to
light the burner by hand.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
•
STOP! Read the safety information above.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance
using the ON/OFF button on the control panel.
Locate manual gas valve to be found on back
side of heater.
3. Turn Manual valve clockwise
OFF position.
4. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor. If
you smell gas, STOP ! Follow "B" in the
safety information above. If you don't smell
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance
using the ON/OFF button.
3. Locate the manual gas valve. Turn the
manual valve clockwise to the full
OFF position.
30
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
OPERATING INSTRUCTIONS
to the full
Manual Valve
CLOSE OPEN

TO TURN OFF GAS TO APPLIANCE

Rinnai Corporation ES38 Manual
• If you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, do not try to
repair it, call a qualified service technician.
Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance
and to replace any part of the control system
and any gas control which has been under
water.
gas go to the next step.
5. Turn the manual gas valve counterclockwise
to the full ON position.
6. Turn on all electric power to the appliance
using the ON/OFF button.
7. Set the thermostat to desired setting.
8. Burner is lit when the combustion indicator
glows red.
9. Combustion indicator flashes when burner
fails to ignite.
10. If the appliance will not
operate, follow the
instructions "To Turn Off
Gas To Appliance" and
call your service
technician or gas
supplier. See manual
for additional
information.
NOTE: The fan will continue to operate until the
appliance is cool. Do not turn the
appliance off by unplugging it from the
wall. Keep burner and control
compartment clean. See installation and
operating instructions.