Holtex+ TysonBio TB100 Manuel D'utilisation page 13

Obtaining a blood sample
A SAMPLE MAY BE OBTAINED FROM the FINGER, PALM or FOREARM
For further instructions please see the insert provided with lancing device.
1.Unscrew and remove the end cap of the lancing device.
2.Insert the lancet into the lancet holder.
3.Twist and remove the protective lancet cover to expose the sterile needle tip.
4.Recap and screw the end cap to the body of the lancing device.
5.Pull back on the cocking mechanism until it comes to a stop.
6.Place the lancing device firmly against the finger tip and press the release button.
7.After sampling, remove the end cap containing the used lancet carefully.
8.Remove the lancet from the lancing device. Discard the used lancet properly in accordance
with local regulations.
Applying blood sample to the test strip
1. After obtaining a blood sample, place the drop on to the test well of the test strip.
Blood is automatically drawn into the test strip.
2. As soon as enough blood has filled the confirmation window (Fig.12) of the
test strip, the meter will beep and begin counting down from 5 to 1.Your
blood glucose result will appear on the LCD display and will be stored into
the meter memory automatically.
Note: To ensure accurate results, make sure the confirmation window of the test strip
is completely filled with your blood sample.
3. After the test result appears, if no further tests are performed, the meter will
automatically shut off after 3 minutes. After finishing the test, use a tissue
paper to remove test strip from the meter for proper disposal.
Warning: Always discharge of the used test strip in a
suitable waste container.
✔
Fig.12
M E
M
13
Code fre e G l ucome t e r