Holtex+ TysonBio TB100 Manuel D'utilisation page 10

10.To set the fourth alarm, press the M
button (no), it will be moved on to health management alarm setting (step
11).
To change the hour, press the S button. To enter the hour
and move on to change the minutes, press the M
the minutes, press the S button. To enter the minutes and move on to health
management"HI alarm setting" press the M
Note: To stop the alarm, press S or M button. The alarm will turn off
automatically after 30 sec.
11.To change the "HI alarm setting" press the S button. To enter the
'HI alarm setting" and move on to "LO alarm setting" press M
button. (Fig.9)
12.To change the "LO alarm setting" press the S button. Further press the
M button to enter the "LO alarm setting" and finish the meter setting.
Turn off the meter. (Fig.9)
Unit selection
Select the unit of measurement mmol/L or mg/dL at the
back of the unit. Note: The mg/dL is the standard unit in
the United States. Meters used in the United States must
be set to read in mg/dL.
button (yes). If you press the S
button. To change
button. (Fig.8)
0000000001
10