Troubleshooting; Plug Safety - Fridja f1400 Mode D'emploi

TROUBLESHOOTING

Problem Reason
Unit fails to steam, Steamer is not
light does not turn on plugged in
Unit fails to steam There is substantial
mineral deposits
throughout the unit
Water storage tank
is empty
'Gurgling' sound from Condensation
hose, steamer head or within the hose
base unit
Steam is intermittent Substantial mineral
deposits in the unit
18
ENGLISH
Solution
Plug the unit into a
suitable power outlet
and turn on if applicable
Follow the remove
mineral deposits
procedure
Fill the water storage
tank
'Gurgling' is normal
during the steaming
process. If there is
excessive gurgling,
extend the hose to allow
excess water to drain
back into the water
storage tank
It is normal for the unit
to periodically stop
steaming for a few
seconds
However if this occurs
for longer periods,
follow the remove
deposits procedure
f1400 FRIDJA PROFESSIONAL GARMENT STEAMER
P LUG S AF ET Y
The appliance is fitted with a 13 amp plug. In the event of having to change
the fuse in the plug supplied, a 13 amp ASTA approved (BS 1363) fuse must
be used. Should the plug need to be replaced for any reason, proceed as
described below. The wires in the mains lead are coloured in accordance
with the following code:
• The wire coloured green and yellow must be connected to the
terminal marked with the letter "E" or by the Earth symbol or coloured
green and yellow. Under no circumstances should either the Neutral or
Live be connected to the earth terminal
• The wire coloured blue or black must be connected to the terminal "N".
Under no circumstances should either the Earth or Live be connected
to the Neutral terminal.
• The wire coloured brown or red must be connected to the terminal
marked "L". Under no circumstances should either the Earth or Neutral
be connected to the Live terminal.
• Upon completion there must be no cut, or stray strands of wire present
and the cord clamp must be secure over the outer sheath.
If in doubt please contact a qualified engineer for advice.
19