Getting Started; General; Installing / Replacing The Battery - Sendoline S5 Apex Locator Manuel De L'utilisateur

7. Getting Started

7.1. General

There are two buttons on the front panel:
On/Off
Volume adjustment
The measuring cable receptacle is located on the left side of the device.
The battery compartment is located on back of the device.
The S5 Apex Locator may be placed in or out of the cradle.
The lip clip, the touch probe and the file clip should be sterilized before use. Please refer
to "Maintenance, Cleaning and Sterilization" section 9 (page 13) for further information
regarding maintenance of the S5 Apex Locator.

7.2. Installing / Replacing the Battery

The S5 Apex Locator is powered by a standard AAA size 1.5V alkaline battery (included)
Prior to battery replacement the device must be turned off.
Before replacing the battery, the measuring cable should be disconnected
from the patient and removed from the S5 Apex Locator device.
7.2.1. To install/replace the battery, unscrew and remove the battery compartment
cover on the back of the device (Fig. 1a). Remove the old battery (if one is
present) using the built-in cloth strip; insert the new battery following polarity
indications marked inside the battery compartment, (Fig. 1b), replace cover
and tighten screw.
Fig. 1a
7
Fig. 1b
.