Heater Kit; Electrical Connections - GE UUY60ZGDAA Instructions D'installation

Installation Instructions

Heater Kit

1. Refer to the table for the appropriate heater kit.
2. Check for any physical damage; do not install a
damaged heater kit.
3. Remove the upper access panel from the air handler.
4. Remove cover plate from air handler.
5. Slide the heater kit into the slot and secure element
plate with previously removed screws.
6. Insert power leads into the circuit breaker lugs or
stripped red and black wires (for heater kit without
circuit breaker) and tighten.
7. Connect ground wire to ground lug.
8. Knock off appropriate area of the plastic circuit
breaker cover on the access panel of the air handler.
Knock off the holes according to the actual installation
number and positions of circuit breakers. If circuit
breaker is not installed, do not knock off the holes,
otherwise there maybe has electric shock occur.
9. Replace access panel and check operation.
10. Finalize power and control wiring.
Cover Plate
Bolt
Circuit Breaker
Fig 2.9
Kit # Description
UAZEH08A 8kW Heater with 45A breaker
UAZEH15A 15kW Heater with 30A and 60A
breakers
14
Heater Kit

Electrical Connections

Connect to 8kw heater Circuit Breaker
Air Handler Supply Voltage
Wire Connections
Field Supply
Ground Wires
208/230 Volt
Field Supply Wires
Connect to 15kw heater Circuit Breaker
Air Handler Supply Voltage
Wire Connections
Field Supply
Ground Wires
208/230 Volt
Field Supply Wires
Connect to Terminal Block
Air Handler Supply Voltage Wire Connections
Field Supply
Ground Wires
ATTENTION: If it is new air handler and it is the first
time install heat, make sure the L1/L2 wire to heater
breaker, then wire the ground wire. Use proper wire
size as specified in this manual for 8K and 15 K heater
assemblies.
If there is no heat kit to install, please make sure wire to
terminal block.
L2
208/230 Volt
Field Supply Wires
L1
31-5000486 Rev. 2