IDEAL SureTrace 61-955 Mode D'emploi page 19

Identifying downstream loads from a breaker.
1) Remove the panel cover and clamp around the hot wire of the energized (closed) circuit.
• To maximize the signal, close the far end of the circuit by plugging in and turning
on a work light or other load into the furthest outlet; hence, making a complete
loop.
2) Hang the battery pack onto the panel with the magnetic strap.
3) Plug the clamp into the battery pack.
4) Set the receiver to the highest sensitivity mode (
outlet while identifying all outlets and loads connected to the circuit. If the Receiver is
saturated, reduce the sensitivity range.
Breaker
Energized
Breaker
Energized
Tracing Conduit.
1) Clamp around the metallic conduit to be traced. If possible, ground the far end of the
conduit to close the loop. This can be created using the 25' lead and alligator clips to clip
onto the end of the conduit or electrical box with one clip and a remote neutral or water
pipe with the other alligator clip.
2) Hang the battery pack onto the panel or conduit with the magnetic strap.
Weaker Signal - Open
Stronger Signal - Closed
Page 19
) and trace the circuit to the furthest
Light On
(Load)