Operating Guide; Application Method; Menu Operations - Gima OXY-200 Mode D'emploi

6 Operating Guide

6.1 Application Method

6.1.1
Inserting the lemo probe into the lemo jack of the device (The probe is limited to the one that is
provided by our company; and can't be replaced with the similar one by other
manufacturers),then put the finger into the probe as Figure 4.
A Long press power button until the device is turned on.If use alternating current,make sure that
the power supply line is connected accurately.
B Do not shake the finger and keep the patient in a stable state during the process.
C The data can be read directly from the screen in the measure interface.
Fingernails and the luminescent tube should be at the same side.
If the alarm function is on, the device will provide alarm signal when probe or finger
is out.
6.1.2 Alarm pause
A Alarm including the alarm of measure data's going beyond the limits, the alarm of low-voltage,
the alarm of finger out.
B When alarm is on,short press the alarm pause button to make the alarm pause, it can renew
alarm after period of time, alarm pause time can be set by menu.
C Only alarm sound can be closed,the prompt information displayed can't be closed.

6.1.3 Menu operations

In the measuring interface, press menu button to enter the main menu interface as figure 5.
Figure 4. Probe connecting
8