Maintenance; General; Daily Cleaning; Replacing Display Light Bulbs - Hatco GLO-RAY GRAM Série Manuel D'installation Et D'utilisation

English

General

Glo-Ray max Watt Strip Heaters are designed for maximum
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAzARD:
• Turn OFF power switch, turn off power at circuit
breaker, and allow unit to cool before performing any
cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.
Use only Genuine Hatco Replacement Parts when service
is required. Failure to use Genuine Hatco Replacement
Parts will void all warranties and may subject operators of
the equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco Replacement Parts
are specified to operate safely in the environments in which
they are used. Some aftermarket or generic replacement
parts do not have the characteristics that will allow them to
operate safely in Hatco equipment.
NOTICE
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch the finish of the unit,
marring its appearance and making it susceptible to soil
accumulation.

Daily Cleaning

To preserve the finish of the strip heater, it is recommended that
all surfaces be cleaned daily.
1. Turn off the unit and allow the unit to cool.
2. Wipe down all metal surfaces with a water-dampened, non-
abrasive cloth. Stubborn stains may be removed with a
good stainless steel or non-abrasive cleaner. Clean hard
to reach areas using a small brush and mild soap.
3. Wipe dry the entire unit using a non-abrasive, dry cloth.
Form No. GRamm-1114

Replacing Display Light Bulbs

Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially coated could result in personal injury and/or
food contamination.
The display light is an incandescent or optional halogen bulb
that illuminates the warming area. These bulbs have a special
coating to guard against injury and food contamination in the
event of breakage.
To replace a display light bulb:
1. Disconnect the power supply and wait until the unit has
cooled.
2. Unscrew the light bulb from the unit and replace it with a
new, specially-coated incandescent or optional halogen
bulb.
NOTE: Hatco shatter-resistant light bulbs meet NSF standards
for food holding and display areas. For 120, 120/208,
and 120/240 volt applications, use Hatco P/N
02.30.043.00.
NOTE: Halogen bulbs are available as an option. For 120,
120/208, and 120/240 volt applications, use Hatco P/N
02.30.081.00.
15

MAINTENANCE

WARNING