Problems And Solutions - Wellis Clement Guide D'utilisation

Problems and solutions

A: The filling valve will not close.
• Open the filling valve cap and clean the valve seal or replace the seal if it is
defective or cracked.
• The float is positioned too high. Position the valve float correctly by adjusting the
threaded mechanism.
• Replace the filter net if it is worn.
• Check the tightness of the structure.
B: Water leaks under the tank:
• The assembly screws must be tightened.
• The sealing between the toilet bowl and the tank is not positioned correctly or is
worn out. Replace the sealing.
C. Poor flush performance
• Adjust the water level inside the tank.
• Check that the water supply valve is fully open.
• Clean the inlets to the drain pipe and the holes at the rim of the toilet bowl to
remove any material that may cause clogging.
D. No flushing
• Check that the water supply valve is closed.
• Check that the water pipe is not blocked.
E. Filling the tank takes a long time.
• Check that the water tank valve is fully open.
• Check that the inlet valve pipe is not leaking.
EN