Finalising The Installation - Wellis Clement Guide D'utilisation

EN
Installing the push button
Replace the tank lid and check the
push buttons.
Adjust the rods as necessary.

Finalising the installation

After the flush button is pressed, there will be a continuous flow of water in the toilet bowl until the
tank is replenished, so as to fill the trap element with the correct amount of water.
Sound pressure when flushing: 85-95 dB
1. Install the toilet seat according to the instruction
guide provided with the seat.
2. Fasten the water connection pipe to the angle
valve permanently. Check for leaks.
3. Apply a suitable sealant between the toilet bowl
and the adjacent surfaces.