Wellis Clement Guide D'utilisation page 7

Setting up the Clement toilet flush and filling valve
Setting the amount of water for a low
volume flush
The amount of water for a low volume
flush can be adjusted with the blue slider
according to the scale located on its left
side.
Adjusting the float height
The float height can be adjusted by
moving the float housing up and down.
This allows you to set the amount of
water used up before the valve starts to
refill.
Setting the amount of water for a high
volume flush
The amount of water for a high volume
flush can be adjusted with the larger blue
adjustment device, again according to the
scale on the left side. (The numbers on
the scales indicate the amount of flush
water in litres.)
After setting the locking element to the
open position, the blue housing can be
moved up and down on the filling valve
housing. After adjustment, the locking
element must be snapped back into the
closed position.
Locking element in the open and
closed positions
open position
EN
closed position