Makita DF012D Manuel D'instruction page 7

Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the light, slide the lamp switch to the A
position. To turn off the light, slide the lamp switch to B
position.
Even if you leave the lamp on, the light will automati-
cally turn off after 5 minutes.
B
A
► 1 . Lamp switch 2. Lamp
NOTE: The lamp signals by flickering during use
when the battery power is almost used up.
At this time, recharge the battery or replace the bat-
tery with a fully charged one.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
Optional accessory
12 mm
(15/32")
Use only the driver bit/socket bit shown in the figure. Do
not use any other driver bit/socket bit.
1
2
9 mm
(3/8")
1
► 1 . Driver bit 2. Sleeve
To install the driver bit, pull the sleeve in the direction of
the arrow and insert the driver bit into the sleeve as far
as it will go.
Then release the sleeve to secure the driver bit.
To remove the driver bit, pull the sleeve in the direction
of the arrow and pull the driver bit out.
NOTE: If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc-
tions above.
NOTE: After inserting the driver bit, make sure that it
is firmly secured. If it comes out, do not use it.
OPERATION
CAUTION:
When bending the tool to use in
the pistol shape or straightening to use in the
straight shape, do not hold the bendable part of
the tool. Failure to do so may cause your hand and
fingers to be pinched and injured by this part.
The tool can be used in two ways; a straight shape and
a pistol shape which are selectable according to the
conditions of workplace and screwdriving.
7 ENGLISH
2