Extension Cords - Weed Eater T100i Manuel D'instructions

• Do not keep battery packs in open sunlight or heat.
Keep battery packs away from fi re.
• Regularly examine the battery pack charger and the
battery pack for damage. Damaged or changed battery
packs can cause a fi re, explosion or risk of injury. Do not
repair or open damaged battery packs.
• Do not use a battery pack or product that is defective,
changed or damaged.
• Do not change or repair products or the battery pack.
Only let your approved dealer do repairs.
• Do not short circuit a cell or battery pack. Do not save
battery packs in a box or drawer where they can be
short circuited by other metal objects.
• Do not remove a battery pack from its initial package
until necessary for operation.
• Do not mechanically shock battery packs.
• If there is a battery leak, do not let the liquid touch the
skin or eyes. If you have touched the liquid, clean the
area with a large quantity of water and get medical aid.
• Do not use a battery charger other than what is specifi ed
for operation with the battery pack.
• Look at the plus (+) and minus (-) marks on the battery
pack and product to make sure of correct operation.
• Do not use a battery pack not made for operation with
the product.
• Do not mix battery packs of a different voltage or
manufacturer in a device.
• Keep battery packs away from children.
• Always purchase the correct battery packs for the
product.
• Keep batteries clean and dry.
• Clean the battery pack terminals with a clean dry cloth if
they become dirty.
• Secondary battery packs must be charged before use.
Always use the correct battery charger and refer to the
manual for correct charging instructions.
• Do not keep a battery pack on continuous charge when
not in operation.
• Save the manual to refer to it in the future.
• Only use the battery pack for its necessary operation.
• Remove the battery pack from the product when not in
operation.
• Keep the battery pack away from paper clips, keys,
nails, screws, or other small metal objects while in
operation. This can make a connection between
terminals. Shorting the battery pack terminals together
can cause burns or a fi re.
CHARGER USE AND CARE
• Before using the charger, read all instructions and
cautionary markings for the charger, battery pack,
and the product using the battery pack.
• Do not allow any liquid to get inside charger.
• To reduce the risk of injury, charge only designated
batteries. The charger and battery pack are specifi cally
designed to work together. Other types of batteries may
burst, causing personal injury and damage.
• Under certain conditions, with the charger plugged
in to the power supply, the charger can be shorted
by foreign material. Foreign materials of a conductive
nature such as, but not limited to, steel wool, aluminum
foil, or any buildup of metallic particles should be kept
away from charger cavities.
• Always unplug the charger from the power supply
8
when there is no battery pack in the cavity.
• The charger is not intended for any uses other than
charging the designated rechargeable batteries. Any
other uses may result in risk of fi re, electric shock or
electrocution.
• Do not expose the charger to rain or snow.
• Pull by the plug rather than the cord when
disconnecting the charger. This will reduce the risk of
damage to the electric plug and cord.
• Make sure that the cord is located so that it will not
be stepped on, tripped over, or otherwise subjected
to damage or stress.
• Do not operate the charger with a damaged cord or
plug. Have them replaced immediately.
• Do not operate the charger if it has received a sharp
blow, has been dropped, or has been damaged in
any other way. Take it to an authorized service center.
• Do not disassemble the charger. Take it to an
authorized service center when service or repair is
required. Incorrect reassembly may result in a risk of
electric shock, electrocution or fi re.
• Disconnect the charger from the outlet before
attempting any cleaning. This will reduce the risk
of electric shock. Removing the battery pack will not
reduce the risk.
• Do not attempt to connect 2 chargers together.
• The charger is designed to operate on standard
household electrical power (120 Volts). Do not
attempt to use it on any other voltage.
ELECTRICAL OUTLETS
a WARNING: Do not touch the terminals of the plug
when installing or removing the plug from the
outlet.
Double insulated chargers are equipped with a polarized
plug (one blade is wider than the other) and will require
the use of a polarized outlet.
The charger plug will fi t into a polarized outlet only one
way. If the plug does not fi t fully into the wall outlet,
reverse the plug. If the plug still does not fi t, contact a
qualifi ed electrician to install the proper outlet. Do not
change or alter the charger plug or the wall outlet in any
way.
Double insulation eliminates
the need for a three-wire
grounded power cord and
grounded power supply
system. This is applicable
only to Class II (double-
insulated) tools. This charger
is a double-insulated tool.
a WARNING: GFCI protection should be provided
on all circuits or outlets to be used for the
charger. Receptacles are available having built-in
GFCI protection and should be used for this
measure of protection.
NOTE: Double insulation does not take the place of
normal safety precautions when using the charger.
Before plugging in the charger, make sure that the outlet
voltage supplied is within the voltage marked on the
charger's data plate.

EXTENSION CORDS

Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result in
risk of fi re, electric shock, or electrocution.