Connect Electrical Supply; Burner Cap Placement - Gaggenau CG 280 210CA Instructions D'installation

9 WARNING
Do not attempt any adjustment of the pressure
regulator.
Connect the gas supply line to the unit pressure
regulator using a 1/2" flex gas line connector between
manual shut-off valve and pressure regulator. Always
use a new flex line.
Figure 9: Gas and Electrical Location
Check supply line connections for leaks using a
soap solution. Do not use a flame of any sort.
1 Turn on gas.
2 Apply a non-corrosive leak detection fluid to all
joints and fittings in the gas connection between
the shut-off valve and the range. Include gas
fittings and joints in the range if connections may
have been disturbed during installation. Bubbles
appearing around fittings and connections
indicate a leak.
3 If a leak appears, turn off supply line gas shut-off
valve and tighten connections.
10
Figure 8: Pressure Regulator
4 Retest for leaks by turning on the supply line gas
shut-off valve. When leak check is complete (no
bubbles appear), test is complete.
5 Wipe off all detection fluid residue.
Important Notes for Gas Connection:
▯
The appliance and its individual gas shutoff valve
must be disconnected from the gas supply piping
system during any pressure testing of that system
at test pressures in excess of 1/2 psig (3.5kPa).
▯
The appliance must be isolated from the gas
supply piping system by closing its individual
manual shut-off valve during any pressure testing
of the gas supply piping system at test pressures
equal to or less than 1/2 psi (3.5kPa).

Connect Electrical Supply

Before connecting 5-foot (1.5 m) supply cord to wall
receptacle, make certain that gas shutoff valve and all
burner controls are in OFF position.

Burner Cap Placement

9 WARNING
To prevent flare-ups, do not use the cooktop
without all burner caps and all burner grates
properly positioned.
9 WARNING
To prevent burns, do not touch burner caps or
grates while hot. Turn the cooktop off and allow
the burners to cool.
Do not attempt any adjustment of the pressure
regulator, except conversion to propane.
The burner caps must be properly placed for the
cooktop to function properly. If the burner cap is not
properly placed, one or more of the following
problems may occur:
▯
Burner flames are too high.
▯
Flames shoot out of burners.
▯
Burners do not ignite.
▯
Burner flames light unevenly.
▯
Burner emits gas odor.