How To Insert The Batteries; How To Use The Remote Control To Operate The Unit; Important - Accorroni CHIP MONO DC INVERTER 2500W Mode D'emploi

: Signal sent confirmation LED
: IFEEL mode indicator
: Fan Speed indicator
: Temperature display indicator

7.3. How to insert the batteries

Use two new alkaline type batteries with AAA 1,5V.
①
Lift the cover along the direction of arrow as shown in the right figure.
② ③
and Remove the used batteries and insert new ones correctly.
④ Reattach the cover by sliding it back into its position.
Notes
♦ Do not use old batteries or different type batteries. Such a use may cause remote
control wrong functioning.
♦ If you do not use the remote control more than two weeks, remove the batteries.
Damages may be caused by possible leakages.
♦ Replace batteries when no "beep" is received from the indoor unit or if the
transmission indicator on the remote controller fails to light.

4.4. How to use the remote control to operate the unit

● SWITCHING THE UNIT ON AND OFF
Press the ON/OFF button to switch the unit on or off. After turning on the air conditioner, operation indicator
unit's display in ON and indoor unit will give a sound.
● SETTING THE OPERATING MODE
By pressing the Mode button several times it is possible to change the unit operating mode. The selected operating mode
symbol appears on the display.
: Automatic mode
: Cooling mode
: Dehumidification mode
: Fan only mode
:Heating mode
♦ When the automatic programme AUTO is selected, the unit will operate automatically according to the ambient
temperature. Set temperature can't be adjusted and will not be displayed as well. Press "FAN" button can adjust fan speed.
Press "SWING" button can adjust fan blowing angle.
♦ When the cooling mode
temperature.
♦ When the dehumidification mode
the ambient temperature and humidity. When the dehumidification mode is in operation, the FAN button cannot be used.
♦ When the heating mode
♦ When the fan mode
environment. Press "FAN" button can adjust fan speed. Press "SWING" button can adjust fan blowing angle..

IMPORTANT!

♦ The unit fan stops when the set temperature is reached and is then automatically reactivated at minimum
speed to prevent air stratification phenomena in the vicinity of the appliance.
♦ When the COOLING,
ANTI-HEATING mode is present. When the HEATING mode is selected, the fan may not start up straight away
because the ANTI-COOLING mode is present.
is selected, the unit operates with a free temperature setting, lowering the ambient
is selected, the unit operates with a free temperature setting, progressively lowering
is selected, the unit operates with a free temperature setting, raising the ambient temperature.
is selected, the unit operates without heating and cooling effect, simply blowing air through the
DEHUMIDIFICATION
→ → → →
mode is selected, the fan may not start up straight away because the
on indoor
28