CAPITAL SPORTS OUTRUN 2XC Mode D'emploi page 43

Emergency Stop Switch
Emergency stop switch is located at G_4.
In an emergency situation, press the
emergency stop switch to disengage it
from the console and the treadmill will
come to a stop quickly. All windows will
show „- -" and the buzzer will beep 12
times synchronously.
Note_ When running on the treadmill, only use the Emergency Stop Switch
in an emergency; when the switch is disconnected from the key panel, the
treadmill will stop quickly, which may cause the loss of balance and possible
injury.
Running Board
Running board is located at G_7. This treadmill is featured with a Four Point
Suspension System which allows the running board a natural deform according
to the weight it bears so as to protect user's knees and thus enhance the
running experience. Before using your product, it is best to take a few minutes
doing some warm up exercises. Remember to check the condition of the
running belt, adjust its tightness and lubricate the treadmill in time.
Side Rail
Side rails are located at G_8/ G_9. The fixed side rail on both sides of the
running belt for user to safely stand over during start-up or in an emergency.
Motor Cover
Motor cover is located at G_10. Do not cover the motor cover to avoid
malfunction or damage caused by excessive motor temperature. Do not step
on or jump on the motor cover.
press
disconnected
To restart the machine, close the
emergency stop switch first, then press
the START button on the key pad of the
treadmill.
close
disconnected
EN
43