Clean The Transfer Ribbon Drawing Roller; Clean The Printhead; Zero Point Adjustment - Carl Valentin DPM IV Guide De Référence Rapide

DPM IV

Clean the Transfer Ribbon Drawing Roller

A B

Clean the Printhead

A B

Zero Point Adjustment

C
B
68
Printing can cause accumulation of dirt at printhead e.g. by colour
particles of transfer ribbon, and therefore it is necessary to clean the
printhead in regular periods depending on operating hours, environmental
effects such as dust etc.
•
Open the cover of print mechanics.
•
Remove the transfer ribbon.
•
Clean the printhead surface with a special cleaning pen or a cotton
swab dipped in pure alcohol.
•
Before using the printing system, let the printhead dry for about two
to three minutes.
A
A soiled drawing roller can lead to reduced print quality and can
affect transport of material.
•
Open the cover of print mechanics.
•
Remove the transfer ribbon from the direct print module.
•
Remove deposits with roller cleaner and a soft cloth.
•
If the roller (A) appears damaged, replace it.
CAUTION!
Printhead can be damaged!

Do not use sharp or hard objects to clean the
printhead.

Do not touch protective glass layer of the printhead.
•
Move the start position of the printing carriage (A) with
the slider (B).
•
If the slider is at shaft end (side panel), the maximum
print length is available.
•
By adjusting the printer zero point, the usable print area
is shortened.
•
Use the zero point adjustment for adjusting the print
position onto the foil.
•
The zero point monitoring is made by an inductive
proximity switch (C).
English