Intended Use; Safety Notes - Carl Valentin DPM IV Guide De Référence Rapide

DPM IV

Intended Use

•
The direct print module is solely intended to print suitable media which have been approved by the manufacturer. Any
other or additional use is not intended. The manufacturer/supplier is not liable for damage resulting from misuse. Any
misuse is at your own risk.
•
Intended used includes heeding the operating manual, including the maintenance recommendations/regulations specified
by the manufacturer.
•
The direct print module may only be used while in proper working order and for the intended purpose. Users must be safe,
aware of potential dangers and must comply with the operating instructions. Faults, in particular those which affect safety,
must be remedied immediately.
•
The direct print module is a state-of-the-art device which complies with the recognized safety-related rules and regulations.
Despite this, a danger to life and limb of the user or third parties could arise and the direct print module or other property
could be damaged while misusing the device.

Safety Notes

WARNING!
The print mechanics is designed to be integrated into a machine. It is essential to ensure that national safety
regulations are observed. Particular attention must be paid to the following points:

The print mechanics must be secured so that it is not possible to reach into the working area during the printing
process.

Operation without additional protective measures can lead to dangerous injuries.

It must be ensured that the required fire-protection device according to IEC 62368-1 is given (see chapter 6.4 in
the IEC 62368-1).
•
The direct print module is designed for power supply systems of 110 ... 240 V AC. Connect the direct print module only to
electrical outlets with a ground contact.
NOTICE!
The protective earthing conductor of the socket is to be examined by a qualified technician.
•
The direct print module may only be operated in the commercial area by persons over the age of 14 who have been
instructed in its use.
•
Couple the direct print module to devices using extra low voltage only.
•
Before making or undoing connections, switch off all devices involved (computer, printer, accessories etc.).
•
Operate the direct print module in a dry environment only and do not get it wet (sprayed water, mist etc.).
•
Do not operate the direct print module in explosive atmosphere and not in proximity of high voltage power lines.
•
Operate the direct print module only in an environment protected against abrasive dust, swarf and other similar impurity.
•
Maintenance and servicing work can only be carried out by trained personnel.
•
Operating personnel must be trained by the operator on the basis of the operating manual.
•
Depending on use, ensure that clothing, hair, jewellery and similar personal items do not contact the exposed rotating parts
and/or the moving parts (e.g. print carriage).
•
The print unit and parts of it (e.g. motor, printhead) can get hot during printing. Do not touch the printhead during operation.
Cool down the print unit before changing material, removal or adjustment.
•
Never use highly inflammable consumables.Carry out only the actions described in these operating instructions. Any work
beyond this may only be performed by the manufacturer or upon agreement with the manufacturer.
•
Unauthorized interference with electronic modules or their software can cause malfunctions.
•
Other unauthorized work or modifications to the direct print module can endanger operational safety.
•
There are warning stickers on the direct print modules that draw your attention to dangers. Therefore the warning stickers
are not to be removed as then you and others cannot be aware of dangers and may be injured.
DANGER!
Danger to life and limb from power supply!

Do not open the casing.
56 English