Table des Matières
Publicité
Programming cooking
A cooking mode must be selected before
programming can take place.
Programming the cooking duration
1. Press the
button several times until the
icon and the three digits on the DISPLAY begin to
flash.
2. Turn the TIMER KNOB towards "+" and "-" to
adjust the duration.
3. Press the
button again to confirm;
4. When the set time has elapsed, the text END
appears on the DISPLAY, the oven will stop cooking
and a buzzer sounds.
• For example: it is 9:00 a.m. and a time of 1 hour
and 15 minutes is programmed. The programme
will stop automatically at 10:15 a.m.
Setting the end time for a cooking mode
A cooking duration must be set before the cooking
end time can be scheduled.
1. Follow steps 1 to 3 to set the duration as detailed
above.
2. Next, press the
button until the
the two digits on the DISPLAY begin to flash.
3. Turn the TIMER KNOB towards "+" and "-" to
adjust the hour value.
4. Press the
button again until the other two
digits on the DISPLAY begin to flash.
5. Turn the TIMER KNOB towards "+" and "-" to
adjust the minute value.
6. Press the
button again to confirm.
7. When the set time has elapsed, the text END
appears on the DISPLAY, the oven will stop cooking
and a buzzer sounds.
• For example: it is 9:00 a.m. and a time of 1 hour
and 15 minutes is programmed, while the end
time is set to 12:30. The programme will start
automatically at 11:15 a.m.
Programming has been set when the
buttons are illuminated. The DISPLAY shows the
cooking end time and the cooking duration
alternately.
To cancel programming, turn the SELECTOR knob to
the "0" position.
Practical cooking advice
Do not place racks in position 1 and 5 during fan-
assisted cooking. This is because excessive direct
heat can burn temperature sensitive foods.
In the SPIT ROAST, BARBECUE and ROASTING
cooking modes, place the dripping pan in position 1
to collect cooking residues (fat and/or grease).
MULTILEVEL
• Use positions 2 and 4, placing the food which
requires more heat on 2.
• Place the dripping pan on the bottom and the rack
on top.
Practical advice on using the electric
hotplates
To avoid heat loss and damage to the hotplates, use
pans with a flat base, whose diameter is no less
than that of the hotplate itself.
Before using the hotplates for the first time, you
should heat them at maximum temperature for
approximately 4 minutes, without placing any pans
on them. During this initial stage, their protective
coating hardens and reaches its maximum
resistance.
icon and
Setting Normal or Fast Plate
and
0
Off
1
Cooking vegetables, fish
Cooking potatoes (using steam) soups,
2
chickpeas, beans.
Continuing the cooking of large quantities of
3
food, minestrone
4
For roasting (average)
5
For roasting (above average)
For browning and reaching a boil in a short
6
time.
GB
35
Publicité
Table des Matières
