Installation Instructions; Before You Begin; Grounding Instructions; Plumbing Requirements - GE Profile WPGT9150 Manuel D'utilisation Et D'installation

Masquer les pouces Voir aussi pour Profile WPGT9150:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: ge.com
In Canada, call 1.800.561.3344 or visit geappliances.ca

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT
– Save these instructions for
local electrical inspector's use.
IMPORTANT
– Observe all governing
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Skill level
Installation of this appliance requires
basic mechanical skills.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty

PLUMBING REQUIREMENTS

WATER PRESSURE – Must be 10 psi minimum to
120 psi maximum.
WATER TEMPERATURE – Household water heater
should be set to deliver water at 120° to 150°F
(50° to 66°C) TO THE WASHER.
SHUTOFF VALVES – Both hot and cold shutoff
valves (faucets) should be supplied.
DRAIN – Water may be drained into standpipe
or set tub. Discharge height MUST NOT BE LESS
THAN 30 INCHES and no more than 8 feet above
the base of the washer. Standpipe must be 1
inches minimum inside diameter and must be
open to atmosphere.
.
1
2
11
FOR YOUR SAFETY:
ELECTRICAL REQUIREMENTS
CAUTION
– For personal safety, do
not use an extension cord or adapter plug with
this appliance. Do not, under any circumstances,
cut or remove the third grounding prong from the
power cord. Follow national electrical codes and
ordinances. This appliance must be supplied with
the voltage and frequency indicated on the rating
plate (located on the rear cover of the backsplash),
and connected to an individual, properly grounded
branch circuit, protected by a 15- or 20-amp circuit
breaker or time-delay fuse. If the electric supply
provided does not meet the above requirements,
call a licensed electrician.

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of
malfunction or breakdown, grounding will reduce
the risk of electric shock by providing a path of
least resistance for electric current. This appliance
is equipped with a cord having an equipment-
grounding conductor and a grounding plug.
The plug must be plugged into an appropriate
outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
WARNING
of the equipment-grounding conductor can result
in a risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to
whether the appliance is properly grounded. Do not
modify the plug provided with the appliance—if it
will not fit the outlet, have a proper outlet installed
by a qualified electrician.
Washer
WPGT9150
– Improper connection

Publicité

Table des Matières
loading

Table des Matières