Calibrating Ship's Speed - Vetus WSD834 Manuel D'utilisation Et Instructions D'installation

Anémomètre/ girouette
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
Use the
or
but-
ton to adjust the wind
direction to '0'.
The original value
can always be reset
by
pressing
the
LIGHT (RESET) but-
ton.
Confirm the calibra-
tion by holding the
SET button pressed
in for 2 sec.
The
screen
will
return to the normal
display.
Wind speed/ wind direction indicator WSD834
WSD834M105
WSD834M106
WSD834M107

4 .3 Calibrating ship's speed

This is only possible if the ship's speed is
known and the instrument receives a signal
giving the speed .
(See Chapter 10 for the connection diagram
for the speedometer signal transmitter.)
The speed signal is necessary in order to be
able to display the True (TRUE) wind speed
and direction and VMG ('Velocity Made Good')
correctly.
In order to calibrate the ship's speed the ship's
actual speed must be known, for example by
an on-board speedometer.
Press the SET button
6 times.
will be dis-
St06
played briefly.
The ship's speed will
be displayed, always
in knots, together
with the calibration
figure as a %.
The calibration figure
will flash.
If there is no speed
signal '
' will be
0 . 0
displayed.
ENGLISH
WSD834M136
WSD834M108
WSD834M109
25
10.0312

Publicité

Table des Matières
loading

Table des Matières