Alarm Situation - Vetus WSD834 Manuel D'utilisation Et Instructions D'installation

and RESET will
AL
flash.
The wind speed
alarm is normally
switched off. This is
shown by '- -' flash-
ing.
The alarm value
can be changed by
pressing the or
button one or more
times.
The default value for
the alarm is 50 kts
(about 25 m/s, 10
Bft).
The alarm will also
be switched on after
the or button has been pressed.
It is always possi-
ble to return to the
original setting by
pressing the LIGHT
(RESET) button.
The alarm can be
switched on or off
again by pressing
the or buttons
simultaneously for a
short time.
Wind speed/ wind direction indicator WSD834
WSD834M126
WSD834M127
WSD834M128
WSD834M129
Confirm the setting
by holding the SET
button pressed in for
2 sec.
When the alarm is switched on
played when in normal display.

3 .5 .4 Alarm situation

The wind speed alarm will be sounded when
the set value is exceeded. This can be either
the apparent wind speed (APP) or the true
wind speed (TRUE) depending on the way the
instrument has been set.
The alarm uses the average wind speed as
reference (see 'Damping' Section 3.5.5). If an
alarm is required for every gust the damping
must be set to 0.
The buzzer will sound
and RESET and the
momentary value of
the wind speed will
flash.
The alarm can be
suppressed by
pressing the LIGHT
(RESET) button.
After this it will always be at least 1 minute
before the alarm can sound again.
ENGLISH
WSD834M130
will be dis-
AL
WSD834M161
WSD834M162
23
10.0312