Troubleshooting - Videotec DTRXDC Manuel D'instructions

Troubleshooting

Although the DTRXDC receiver is characterized by a great ease of use, sometimes troubles may occur, especially
during the installation and configuration phases or using the unit..
Led LD8 is off
Led LD8 is on.
The instruction are not
executed
The Pan & Tilt does not
work
The lens does not work
In a cascade connection,
the units which follow do
not receive the user's
commands
 No power supplied to the unit
 The fuse is blown
 Wrong configuration of the reception
 Wrong connection
 Wrong DTRXDC identification
 Wrong speed
 The unit is blocked
 Wrong connection of Pan & Tilt
 Wrong lens voltage
 Wrong connection of lens
 Wrong connection
 Wrong configuration of the reception
 Wrong speed
 Check the power cord
 Replace the F1 fuse
 Control the JP1 jumper
 Check the connecting cables
 Control the DTRXDC identification number
 Check the position of switches 6 and 7 of
dip-switch SW2
 Press the BP1 reset button or turn off the
power
 Check the connection cables of Pan & Tilt
 Check the connection cables of lens
 Control the adjustment of the TR1 trimmer
 Check the connetion cables
 Check the jumper JP1
 Check the position of switches 6 and 7 of
dip-switch SW2
Page. 13 MNVCDTRXDC_1511_EN