Scrambler Ducati CITY CROSS-E Mode D'emploi page 8

4. Brake - e-brake + disc brake, when brake, the rear light will be flashing.
5. How to change speed? After power on, default is the lower speed. Switch the speed by
quick pressing two times the Power On/off button
6. Battery indicator
• 33v-36v
• 36v-37v
• 37v-38.5v
• 38.5v above
Low voltage warning: the 1st battery bar flashing once voltage is lower than 33V
7. Low voltage warning mode: Under this mode, the speed limitless is 6Km/h.
8. Auto Cruise - Speed Cruise activated automatically after same speed for 10 seconds, then
you can release the speed controller; press brake controller or press again the speed
controller, scooter returns back to manual mode.
9. Speed Setting:
• White S <=6km/h
• Orange S<= 15km/h
• Red S<= 25km/h
10. Auto Power off - After 10mins without any operation, it will be powered off automatically
Function Fault:
Fault Code
E.1
E.2
E.3
E.4
E.5
E.6
E.7
E.8
Pressing the Accelerator lever, up to the maximum travel, for 10" (seconds)
ATTENTION
the scooter will maintain the same speed even when releasing the lever.
Check the battery charge level with the vehicle stationary.
ATTENTION
One battery bar light
Two battery bar light
Three battery bar light
All battery bar light
Instruction
E-accelerator fault
Battery voltage over 42V
Battery voltage below 32V
Output Current exceeds 14A
Motor Hall wire fault
Motor stuck
Motor phase line fault
Front or Rear Light failure
within 1 second.
06