Automatic Fault Warnings - Summit DW242WADA Manuel D'utilisation

AUTOMATICE FAULT WARNINGS
TROUBLE
CODE
FF Water inlet system failure
F5 Pressure system failure
Continuous water input
F3
Inability to discharge water
F2
F8
F1
Faulty electronic card
FE
F7
Divisor position error
F9
Faulty heater sensor
F6
High voltage failure
HI
Practical Information
When the machine isn't in operation:
•
1. Disconnect the plug and close the tap.
2. Leave the door slightly open to prevent odour formation.
•
Select the dry option to remove water droplets.
•
Place dishes in the machine properly to achieve the best energy consumption, washing and
drying performance. Please see the program and consumption table for more information.
•
Rinse dirty dishes before placing them in the dishwasher.
•
Only use the Rinse program when necessary.
•
Do not place the machine near a refrigerator because it will reach high temperatures.
•
If the machine is located in an area that is at risk of freezing, close the tap, disconnect the inlet
hose from the tap and drain the water inside the hose and the machine completely. penses
outside the metropolitan region.
POSSIBLE FAULT
Heater error
Overflow
Overheating
WHAT TO DO
Make sure the water inlet tap is open and water is
flowing.
Separate the inlet hose from the tap and clean the
filter of the hose.
Contact for service if the error continues.
Contact for service.
Close the tap and contact for service.
Water discharge hose and filters may be clogged.
Cancel the program.
If the error continues, contact for service.
Contact for service.
Unplug the machine and close the tap.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
31