Starting The Program; Cancelling The Program; Salt Indicator; Rinse-Aid Indicator - Summit DW242WADA Manuel D'utilisation

To cancel the Delay Timer function:
1. Open the door of the dishwasher.
2. Press and hold program Delay Timer key for 3 seconds.
3. At the end of 3 seconds, the delaying process will be cancelled.
a. You can select and start a new program following the cancellation of Delay Timer function.
b. Delay Timer function cannot be set after the program starts.

Starting the Program

•
Open the door of your machine, select the appropriate program and auxiliary functions, press the
Start/Pause + On/Off key, and close the door within 4 second.
•
Once the program starts, the estimated time remaining to the end of the program will appear on
the display.
o
Your machine performs water softening depending on the hardness level of the water supply.
Remaining time displayed towards the end in some programs can be different from the time
indicated at the beginning due to this process. The total time can also change while the
program is running, depending on the ambient temperature where your machine is installed,
temperature of the supply water, and amount of the dishes.
o
Try not to open the door of the machine when it is running. Stop the machine by pressing
Start/Pause key as soon as the door of the machine is opened. In other situation, the
machine will stop automatically after 4 seconds when the door of the machine is opened and
any key is not pressed.
o
If the door is opened while the machine is running, the machine will switch to the standby
mode. Press Start/Pause key and close the machine door within 4 seconds, then the
program will resume.

Cancelling the Program

1. Press the Selection + Cancel key for 3 seconds to cancel the program.
2. After 3 seconds, "1" will appear on the display. For a couple of minutes, the machine will fulfill the
necessary operations required to cancel the program.
3. There might be residues of detergent or rinse aid left in the machine and/or on the pieces being
washed, depending on the step the program you have cancelled was in.
Salt Indicator (Model Depending)
Please check the salt indicator on the control panel to see whether there is an adequate amount of
softening salt in the dishwasher. You need to refill the salt reservoir with salt whenever the salt
warning indicator appears on the control panel of your machine.

Rinse-Aid Indicator

Please check the rinse aid indicator on the control panel to see whether there is adequate amount of
rinse aid in the dishwasher. You need to refill the rinse aid reservoir with rinse aid whenever rinse
aid warning indicator appears on the control panel of your machine.

End of Program

"00" will be displayed when the washing programm is finished.
1. Open the door of the machine.
2. Press Start/Pause + On/Off key to turn off your machine.
a. Leave your dishes in the machine for about 15 minutes to cool down after they are washed.
Your dishes will dry in a shorter time if you leave the door of your machine ajar during this
period. This process will increase the drying effectiveness of your machine.
25