Troubleshooting - Summit DW242WADA Manuel D'utilisation

FAULT
The program does not
start.
Water remains inside
the machine.
Machine stops during
washing.
Shaking and hitting
noises are heard during
a wash operation.
Partial food wastes
remain on the dishes.

TROUBLESHOOTING

POSSIBLE CAUSE
Your Dishwasher is not plugged
in.
Your Dishwasher is not switched
on.
Fuse blown.
Water inlet tap is closed.
Your Dishwasher door is open.
Water inlet hose and machine
filters are clogged.
Water drain hose is clogged or
twisted.
The filters are clogged.
The programme is not finished
yet.
Power failure.
Water inlet failure.
The spray arm is hitting the
dishes in the lower basket.
Dishes placed incorrectly,
sprayed water not reaching
affected dishes.
Dishes leaning each another.
Not enough detergent used.
Wrong wash programme
selected.
Spray arms clogged with food
waste.
Filters or water drain pump
clogged or filter misplaced.
TROUBLESHOOTING
Plug your Dishwasher in.
Switch your Dishwasher on by
pressing the On/Off button.
Check your indoor fuses.
Turn on the water inlet tap.
Close the Dishwasher door.
Check the water inlet hose and
machine filters and make sure they are
not clogged.
Check the drain hose, then either
clean or untwist it.
Clean the filters.
Wait until the programme is finished.
Check mains power.
Check water tap.
Move or remove items blocking the
spray arm.
Do not overload baskets.
Place dishes as instructed in the
section on loading your dishwasher.
Use the correct amount of detergent,
as instructed in the programme table.
Use the information in the programme
table to select the most appropriate
programme.
Clean the holes in the spray arms with
thin objects.
Check the drain hose and filters are
correctly fitted.
29