Fire Safety - KIRAMI TUBE Notice D'emploi

TUBE Outside heater for wooden hot tubs- User manual Page 14/44
case. Also build a support for the heater when it is not fixed on the tub. And remember to
empty the heater from its own valve after use.

Fire safety

If the heater is located near buildings, for example
on the side of a terrace, the distance of the
chimney from any combustible materials must be
adequate. Remember to check the distance both
laterally and vertically so that there isn't any risk of
fire. Safe minimum distance, from the chimney's
upper end, laterally is three (3) meters. Shorter
distance laterally is adequate in other parts of the
chimney. If the chimney is closer to any
combustible materials you must use special
insulated chimney, which has to be purchased
separately.
When positioned close to the roof or when taken through it, the top end of the insulated
chimney must be at least one (1) meter above the surface of the roof. Ask your local fire
officer for more information.
Notice also the fire safety in front of the furnace. There shouldn't be any combustible
materials in front of the furnace. There should be an area, which is demonstrated in the
picture that should be made of incombustible material such as concrete, sand or metal.
Grates
For the TUBE heater, two cast iron grates and one L-shaped iron plate
will be delivered. Those are to be positioned on the tracks in the
heater. The order of the grates is shown on the right side. L-shaped
iron plate is to be installed bended edge upwards. It will deflect the air
and also prevent the firewood to drop out from the heater.
Chimney
You can use a Ø150mm outer diameter acid-proof chimney with this heater. The reduced
end of the chimney fits inside the heater. The chimney parts can be purchased separately in
three different lengths: 25 cm, 50 cm and 100 cm. There are also available adjustable
chimney corners and 100 cm long protective sleeves for the lower part of the chimney.
We recommend a chimney kit for the heater. This package
includes 200 cm chimney + 100cm protective sleeve and a
standard hat. There are also spark protective hats available
for the chimney.
If you have purchased a chimney kit with the heater. It is
supplied in a separate box and has four parts (see picture
right) and it has to be assembled.
Remove the protective film from the thermal protection and
place the assembled chimney to the chimney outlet of the stove.
Be careful, the edges of the chimney are very sharp. Use protective gloves!
© Kirami Oy, Finland
Updated 09/2017