Water Discharge; Fire Safety - KIRAMI Original Tiny S Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48
© Kirami Oy, Finland

Water discharge

The water discharge is the pipe (2 ½" female thread) on the opposite
side of the stove. Where the supplied shut-off valve with a 38 mm
hose coupling is installed. Plan the location of your tub so that the
water discharge will not cause any problems. Guide the water to the
side with hoses – hoses with a 38 mm ID can be used.
1. Use pipe tape in valve thread connection about 15 rounds
thickening towards the base of the thread.
2. Install the valve in its place. Turn the valve MAX 10 times
clockwise. Stop turning the valve in correct position at once.
Since turning back might leave the tape sealing leaking. The
correct position is marked with upward arrow and word UP.
The thread of the valve is not meant to go all the way in.
3. Assembly of the plug.
4. Notice that the end of the bolt shall enter the matching inlay
in the valve.
5. Tighten the plug by turning the ring nut clockwise. Do not
overtighten, only turn half a turn at once until the water stops running.
6. The plug is opened by turning the ring nut counter clockwise and pulling it horizontally out
from the valve. If the plug seems to be stuck. Wait for a few minutes so the plugs shape
reverts. That way it will come out easier.
7. When water starts running, tighten the plug so it stays in.
Notice! Do not leave the plug tightened in for prolonged periods of time to ensure that it does not
get stuck in the valve body.
In case the tub is placed near buildings, e.g. the edge of a terrace, ensure that the chimney top is
located away from flammable
materials. Remember to check the
distance both sideways and vertically
in order to avoid the risk of fire. Local
rules may vary.
There should be no flammable material
located in front of and below the
furnace. In practical terms, this means
that an area of incombustible material,
such as concrete, sand, or a metal
plate, is needed in front of the furnace.
The stove will not heat up above the
water temperature as the stove is
surrounded by a water jacket. The chimney and door of the stove will heat up, however.
INSTRUCTIONS FOR USE: Original Tiny ™ hot tubs
28/86

FIRE SAFETY

4 / 11
01.03.2022

Publicité

Table des Matières
loading

Table des Matières