BABYTREND PY86K Manuel D'instruction page 20

Table des Matières

Publicité

ASSEMBLY MONTAJE ASSEMBLAGE
TO REMOVE CHANGING TABLE
PARA RETIRAR EL CAMBIADOR
POUR ENLEVER LA TABLE À LANGER
25) • Flip Changing Table to the outside of the
Playard. Unsnap fabric flap of Changing
Table from Playard. Twist Connector Knobs
clockwise to unlock (Fig. 25a). Remove
Changing Table from Playard (Fig. 25b) and
disconnect the Short Bars from the Curved
Bar by pressing on the snap buttons and
pulling apart. Remove Curved Bar from
Changing Table sleeve.
• Voltee el Cambiador afuera del Corralito.
Desabroche del Corralito la solapa de tela
del Cambiador. Gire las Perillas conectoras
en el sentido de las agujas del reloj para
destrabarlo (Fig. 25a). Retire el Cambiador
del Corralito (Fig. 25b) y desconecte las
Barras cortas de la Barra curvada oprimiendo
los botones a presión y desmontándolas.
Retire la Barra curvada de la manga del
Cambiador.
• Basculer la table pour être à l'extérieur du
parc. Détacher le tissu de table du parc de
bébé. Tournez les boutons connecteurs
dans le sens des aiguilles d'une montre pour
déverrouiller les boutons (Fig. 25a). Retirez
la table du parc (Fig. 25b) et débranchez les
barres courtes des longues barres courbe en
appuyant sur les boutons et tirant. Retirez les
longues barres courbes du tissu de la table à
langer.
37
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY MONTAJE ASSEMBLAGE
PARENT ORGANIZER ASSEMBLY
ARMADO DEL ORGANIZADOR PARA PADRES
ASSEMBLAGE DE L'ORGANISATEUR POUR PARENT
26) • Parent Organizer: Position each hook so that
Fig. 25a
• Connect the Parent Organizer/Diaper
Fig. 25b
Parent Organizer
Organizador para padres
Organisateur pour parent
the hooked end is facing the rear side of the
organizer (Fig 26a). Press the hook down
firmly into the slot until it snaps into place
(Fig. 26b). Diaper Stacker: Skip to (Fig 26c).
Stacker to the Playard by sliding the two (2)
connecting clips over an open portion of the
top rail of the Playard (Fig. 26c).
NOTE:
The Parent Organizer/Diaper Stacker
can only be installed on open sides of the
Playard where the connecting clips can easily be
attached without interfering with other features.
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
or
Diaper Stacker
o
Portapañales
Pochette de diaper
ou
Fig. 26a
Parent Organizer
Organizador para padres
Organisateur pour parent
Fig. 26b
38

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Py86c04k

Table des Matières