Manufacturer's Warranty; Further Information - Hilti SF 10W--A22 Notice D'utilisation Originale

Trouble or fault
Product does not work.
Product does not work and all
four LEDs flash.
Product does not work and
one LED flashes.
The on/off button cannot be
pressed, i.e. the button is
locked.
The battery runs down more
quickly than usual.
The battery doesn't engage
with an audible double click.
The product or battery gets
very hot.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12

Further information

For more information on operation,
qr.hilti.com/manual/?id=2130486
This link is also to be found at the end of the operating instructions, in the form of a QR code.
*2130486*
Possible cause
The battery is not fully inserted.
Battery is discharged.
Product momentarily overloaded.
The overheating cut-out has been
activated.
Battery is discharged.
The battery is too hot or too cold.
The forward/reverse selector
switch is in the middle position.
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
The product is overloaded (appli-
cation limits exceeded).
technology,
2130486
Action to be taken
▶ Push the battery in until it
engages with an audible double
click.
▶ Change the battery and charge
the empty battery.
▶ Release the control switch and
then press it again.
▶ Allow the product to cool down.
Clean the air vents.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended operating temperature.
▶ Push the forward/reverse switch
to the left or right.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lugs and
push the battery in until it
engages. Contact Hilti Service
if the problem persists.
▶ Pay attention to the power
and performance rating of the
product before using it, i.e
check its suitability for the job
on hand. See "Technical data"
section.
environment and recycling, follow this link:
English 11