Pioneer N-30AE Manuel D'instructions page 9

> Before Start > Part Names
The control jack
By connecting Pioneer brand amplifiers or CD players, for
example, that have control jacks using monaural miniplug
cables (without resistors), you can centralize control of the
devices using the Pioneer Remote App.
Furthermore, even when the other devices are put in places
where the remote control signal is unable to reach, you can
enable operation of the other components through the
remote control sensor of this unit.
0 Also make sure to connect with the analog audio cable.
Centralized control cannot work correctly with only the
control jack connection.
0 With this connection, the remote control sensors on the
amplifier and CD player stop working. Point the remote
controller at remote control sensor of this unit.
a Monaural miniplug cables (without resistors)
8
> Install > Initial Setup
N-30AE
a
CONTROL
a
CONTROL
> Playback
IN
OUT
Amplifier
IN
OUT
CD player
Advanced Setup | Firmware Update | Others
E
N