Klarstein 10031434 Mode D'emploi page 35

Press T-ON button to initiate the auto-ON timer. To cancel the auto-timer program, sim-
ply press this button again.
After press of this button [ ] disappears and „ON „blinks .00:00 is displayed for ON time
setting.Within 5 seconds,press + or - butt on to adjust the time value.Every press of either
T-ON/
13 button changes the time setting by 1minute. Holding down either button rapidly changes
T-OFF
the time setting by 1 minute and then 10 minutes.Within 5 Seconds after setting,press
TIMER ON button to confirm.
Press T-OFF button to initiate the auto-off timer. To cancel the auto-timer program, sim-
ply press the button again.TIMER OFF setting is the same as TIMER ON.
Press this button to activate/deactivate the Turbo function which enables the unit to reach
the preset temperature in the shortest time. In COOL mode, the unit will blow strong
14 TURBO
cooling air at super high fan speed. In HEAT mode, the unit will blow strong heating air at
super high fan speed.
Press LIGHT button to turn on the display's light and press this button again to turn off the
15 LIGHT displays light. If the light is turned on [ ] is displayed. If the light is turned off, the symbol
disappears.
Pressing X-FAN button in COOL or DRY mode,the icon [ ] is displayed and the indoor
fan will continue operation for 10 minutes in order to dry the indoor unit even though you
16 X-FAN
have turned off the unit. After energization, X-FAN OFF is defaulted. X-FAN is not available
in AUTO,FAN or HEAT mode.
Combination of „+" and „-" buttons: About lock Press „ + „ and „-" buttons simultaneously
17 to lock or unlock the keypad. If the remote controller is locked, [ ] is displayed. In this
case, pressing any button, the symbol blinks three times.
Combination of „MODE „ and „-" buttons : About switch between Fahrenheit and centigrade. At unit
18
OFF, press"MODE „ and"-" buttons simultaneously to switch between °C and °F.
Combination of „TEMP„ and „CLOCK" buttons (COOL mode): About Energy-saving Function. Press
19 „TEMP" and „CLOCK" simultaneously in COOL mode to start energy-saving function. Nixie tube on
the remote controller displays „SE". Repeat the operation to quit the function.
Combination of „TEMP„ and „CLOCK" buttons (HEAT mode): Press „TEMP" and „CLOCK" simultane-
20 ously in HEAT mode to start 8°C Heating Function. Nixie tube on the remote controller displays [ ] and
a selected temperature of „ 8°C". (46°F if Fahrenheit is adopted). Repeat the operation to quit the function.
21 Back-lighting Function: The unit lights for 4s when energizing for the first time, and 3s for later press.
35