Location And Function Of Parts - Sony BRU-SF10 Mode D'emploi

Notes
• To start the system, first turn on the power of the
BRC-Z330 camera, then turn on the power of the
BRU-SF10 (this unit). Otherwise, the error message
"Communication error Please check connection" may
appear.
• Be sure to configure the same image frequency for
both the BRC-Z330 and this unit. 1080i and 760p
video settings configured on the BRC-Z330 will be
automatically applied to the BRU-SF10.
Location and Function
of Parts
Front
1 2 3 4 5
ON/STANDBY
LINK
ALARM
DATA MIX SD
OFF ON
8
A Power switch
Turns on/off the power of this unit. Turn on the
power of the BRC-Z330 camera before you turn on
this unit.
B Power indicator
Off: The unit's power switch is turned off.
Lit orange: The unit is starting up or in sleep mode.
Lit green: The unit is in normal operation.
C LINK indicator
Lit green: The optical fiber connection between the
unit and the camera is normal. (The indicator
lights green after the system starts up.)
Lit red: Check for the following.
• The BRU-SF10 is not properly connected to
the camera via optical fiber cable. Check the
connections, and restart the unit.
• Image frequency settings for the camera and
the BRU-SF10 are different. Check the
settings after turning off the power, and then
restart the unit.
• The camera may be unable to start properly
due to the AC adapter being improperly
connected to the DC IN connector on the
camera. Check that the camera is turned on.
6
1 2 3 4 5 6 7
7
1080i 59.94 RS232C 9600bps
720p 50 RS422 38400bps
HD OPTICAL MULTIPLEX UNIT

Location and Function of Parts

5
GB