• Keep holding the handle while
opening the PSU unit and place
your second hand underneath
the LCD display area to stabilize
it. Then pull the unit towards
the rear to remove.
• Warning : Ensure that the security
bent plate has been pulled out
from the slot.
5.2 Analysis
If there is still a problem after the troubleshooting procedure (see part 6) has been performed,
contact your Robert Juliat distributor with the following information:
•
Model, version and serial number of the product.
•
Software version (page EN-15, section 4.2.2).
•
Description of the problem.
5.3 Thermal protection
In case the thermal protection starts :
•
Check possible overheating indications (page EN-31).
•
Reset the thermal protection by pressing the "ON/OF" button.
5.4 Exploded view / Spare parts list
Available on
⇒
Or on request through the Robert Juliat Service department
⇒
www.followspot-merlin.com
or
www.robertjuliat.com
EN - 27 -
info@robertjuliat.fr
EN