Electrical Connection - ETNA EEK262VA Mode D'emploi

SAFETY
• The rear of the appliance must stand against the wall.
• Do not install the appliance where there is direct sunlight.
• Do not install this appliance in areas that are too humid or
too colds, such as the construction appendices, garages or
wine cellars.
• When you move the appliance, lift it by the front edge to
avoid scratching the floor.

Electrical connection

• WARNING! Risk of fire and electrical shock.
• The appliance must be earthed.
• All electrical connections should be made by a qualified
electrician.
• Make sure that the electrical information on the rating plate
agrees with the power supply. If not, contact an electrician.
• Always use a correctly installed shockproof socket.
• Do not use multi-plug adapters and extension cables.
• Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable, compressor).
Contact the Service or an electrician to change the electrical
components.
• The mains cable must stay below the level of the mains
plug.
• Connect the mains plug to the mains socket only at the end
of the installation. Make sure that there is access to the
mains plug after the installation.
• Do not pull the mains cable to disconnect the appliance.
Always pull the mains plug.
EN 6