Drive Unit Setting Data Backup Function; Connection And Communication With The Pc; Downloading Application - Shimano Steps RIDE+ Manuel Du Propriétaire

Drive unit setting data backup function

The data saved to the drive unit is usually backed up automatically. However, performing the following operations will cause
a message to appear asking whether or not to update the backup data.
• Reinstalling the cycle computer on a bicycle with different settings.
• Changing the drive unit settings for an E-TUBE PROJECT.

Connection and communication with the PC

„ Downloading application
You need E-TUBE PROJECT to configure SHIMANO STEPS and update firmware.
Download an E-TUBE PROJECT from the support website (http://e-tubeproject.shimano.com).
For information on how to install an E-TUBE PROJECT, check the support website. For information on how to operate the PC,
refer to the help manual on the E-TUBE PROJECT.
Connection and communication with a PC is not possible while charging.
• You need SM-PCE1 and SM-JC40 / JC41 to connect SHIMANO STEPS to a PC.
• Firmware is subject to change without notice.
If necessary, contact the place of purchase.
CAUTION
43