Yamaha F200 Manuel De L'utilisateur page 92

Maintenance
1. Bolt
2. Apron
6. Prepare a suitable container that holds a
larger amount than the engine oil capac-
ity. Remove the drain screw and gasket
while holding the container under the
drain hole. Let the oil drain completely.
Wipe up any spilled oil immediately.
1. Drain screw
2. Gasket
TIP:
If the oil does not drain easily, change the tilt
angle or turn the outboard motor to port and
starboard to drain the oil.
86
7. Put a new gasket on the drain screw. Ap-
ply a light coat of oil to the gasket and in-
stall the drain screw.
Drain screw tightening torque:
27 Nm (2.75 kgf-m, 19.9 ft-lb)
TIP:
If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into
contact with the surface of the drain hole.
Then tighten 1/4 to 1/2 turn more. Tighten the
drain screw to the correct torque with a
torque wrench as soon as possible.
8. Add the correct amount of oil through the
filler hole. Put back the filler cap and the
dipstick. NOTICE: Overfilling the oil
could cause leakage or damage. If the
oil level is above the upper level mark,
drain until the level meets the speci-
fied capacity.
Recommended engine oil:
YAMALUBE 4M FC-W or 4-stroke
outboard motor oil
2 1
Engine oil quantity (without oil filter
replacement):
Engine oil quantity (with oil filter re-
placement):
9. Leave the outboard motor for 5-10 min-
utes.
ZMU02145
10. Remove the oil dipstick and wipe it
clean.
11. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
[ECM01851]
4.5 L (4.76 US qt, 3.96 Imp.qt)
4.7 L (4.97 US qt, 4.14 Imp.qt)