Seac Q3 Instructions page 14

• Shock-resistant ABS body.
• Spotlight optics.
• Polycarbonate glass lens.
• Non-slip thermorubber ring nut body.
• Mechanical microswitch.
• 3 high light efficiency LEDs, Color temperature 6,000 °K
• Twin O-ring fitted on lens seal.
• Battery holder specially shaped for parallel use of 4 or 8 batteries.
CHARACTERISTICS
Output
Volt
Type of batteries
Lumens rating
Battery housing
Light source
Color temperature
Light beam
Burntime, hours *)
Maximum depth
*) The burntime shown is approximate because it depends on the quality of
the batteries used. We recommend using high quality alkaline batteries. 1.2 V
rechargeable batteries commonly found on the market can also be used. If
rechargeable batteries are used we cannot guarantee the burntime and light
output shown on the technical sheet.
14 English
960-manuale seac Q3-Q1-rev B.indd 14
TECHNICAL SPECIFICATIONS
6 W
5.0 V
Requires the use of 1.5 V (R6) AA alkaline
batteries. 1.2 V rechargeable batteries of the
same size can also be used.
360
Compartment specially configured for use of 4 or
8 batteries in parallel
3 LEDs
6,000 °K
Concentrated
9 at full power
Over 20 at reduced power
100 m
Q3
08/02/2016 11.13.02