Kobalt XC302000 Manuel D'utilisation page 16

CARE AND MAINTENANCE
1. Disconnect power cord plug from power
source receptacle. Clean debris from motor,
flywheel, tank, air lines and pump cooling fins.
2. Maintain proper oil level. Refer to Lubrication
section for details.
3. Change oil.
a. Allow compressor to run and warm up oil.
Disconnect power cord plug from power
source receptacle.
b. Position a pan under pump.
c. Remove oil drain plug (See Figure 1).
Allow oil to collect in pan.
d. Replace drain plug, fill pump to full level
(See Figure 1). See Lubrication section of
this manual.
4. Drain Tank. Disconnect, tag and lock out
power source; release pressure. Drain
moisture from tank by opening drain valve
underneath tank (See Figure 2).
MOISTURE IN COMPRESSED AIR
Moisture in compressed air will form
into droplets as it comes from an air
compressor pump. When humidity is high
or when a compressor is in continuous
use for an extended period of time, this
moisture will collect in the tank. When
using a paint spray or sandblast gun,
this water will be carried from the tank
through the hose, and out of the gun as
droplets mixed with the spray material.
IMPORTANT: This condensation
will cause water spots in a paint job,
especially when spraying other than
water based paints. If sandblasting, it
will cause the sand to cake and clog the
gun, rendering it ineffective. A fi lter in the
air line, located as near to the gun as
possible, will help eliminate this moisture.
5. Check air filter to be sure it is clean. Replace
filter if filter is dirty.
1
Sight
Glass
Oil Drain
Plug
2
16
Oil Fill Area