wavin Sentio Guide Rapide page 18

Masquer les pouces Voir aussi pour Sentio:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
Global peripherals
Global peripherals, as Extension Units (V, VI), Outdoor Sensor (VIII) and Commissioning Touch Screen (VII), collect and display
values that are used to control the entire Sentio system or are used to extend the Sentio system.
The global components have to be registered to the CCU. Usually they are automatically enrolled and registered at the
system startup. The only global component that is not automatically registered is the Wireless Outdoor Temperature Sensor.
It is registered following this way:
1. P ress button F the CCU (IV) as long till the LED E is flashing red.
2. I nsert the battery(s) into the outdoor temperature sensor. The LED E on the CCU now will glow green.
Local peripherals
Local peripherals, as room thermostats and room sensors, collect and display values for the room they are mounted in.
A total of 24 Local peripherals can be registered to one CCU.
Before the system can be used all local peripherals have to be registered to the channel(s) they have to control.
They are registered in the following way:
1. P ress button F or K on the CCU (IV) until the LED next to the channel you want to register the thermostat/sensor
to is flashing red.
2. a ) Wireless peripherals: Insert the batteries into the room thermostat / sensor (see manual added to the package)
b) W ired peripherals: Touch the room thermostat / sensor touch area and hold it for approx. 5 sec
(see manual added to the package).
When the CCU has received the enrollment code from the room thermostat / sensor the light next to the channel you
choose will switch to continuous on.
3. I f more than one channel has to be registered to the same room thermostat / sensor, repeat step 1 and 2
Repeat the above for the other room thermostats / sensors to be registered.
If you have to remove a local peripheral from the system follow this steps:
1. P ress button F or K on the CCU (IV) or Extension Unit (V, VI) until the desired channel flashes red.
2. H old button H on the CCU (IV) or Extension Unit (V, VI). The LED next to the relevant channel turnes off.
Actuators
The actuators are supplied open and will not close until they have been activated for 10 minutes. If an output has not been
activated within two hours after starting the CCU, it will automatically activate the channel to close the actuator.
In total max. 16 acutators can be connected to a CCU/EU combination!
7
7

Publicité

Table des Matières
loading

Table des Matières