Urmet 1083/67 Mode D'emploi page 11

a wireless call repeater Ref. 4311/13. This ringer is activated during every call ring tone.
CONFIGURATION IN SWITCHBOARD MODE
§
For dip-switch settings, see the system manual provided with the power supply Ref. 1083/20.
To install the interface confi gured in switchboard mode, follow the installation manual provided with the
switchboard. Also in this case, to evaluate the max. number of devices that can be installed in column, note
that each apartment interface must be considered as 2 apartment stations.
CODE: user code.
§
Set the Dip 1 CODE in ON position.
Set a number from 0 to 63.
§
To set the desired code, use the dip-switches CODE from 2 to 8 (2= most signifi cat bit – 8=less
signifi cant bit).
INT:
apartment internal code.
Set all dip switches in OFF position.
Program a function button (F4, F5 or F6) of the concierge switchboard for the call transfer on the interface
with the code set in CODE (3 digits max.).
FEATURES IN SWITCHBOARD MODE
RECEIVING CALLS IN SWITCHBOARD MODE
To activate the call transfer from the switchboard to the interface, press the previously confi gured function
button (F4, F5 or F6).
The switchboard display shows
where:
ddddd is the code CODE set on the interface Ref. 1083/67, which manages the diverted call.
Now calls are intercepted according to the following rules:
• If the switchboard is in "day" mode, when the transfer is activated, all the calls coming from the main
stations and all the calls coming from the apartment stations and addressed to the switchboard make the
telephones connected on au, bu ring.
• If the switchboard is in "night" mode, when the transfer is activated, only the calls coming from the
apartment stations and addressed to the switchboard make the telephones connected on au, bu ring.
To disable the call transfer from the switchboard to the interface, press again the function button (F4, F5 or
F6) which had activated the service.
§
The other switchboard functions are not available when the call transfer is active. In this case, the
switchboard can only disable the function.
DS1083-021B
DIVERTED TO:
13/03/2010
ddddd
15:30:30
11