Install Battery; Insert Micro Sd Card - Celestron INFINIVIEW 44360 Manuel D'instruction

3. sETUP

INsTAll BATTErY

Open the Battery Compartment and insert the lithium battery,
making sure to align the connection points correctly.
NOTE:
Although the battery has a partial charge, if you are going to use the microscope
with the battery only, be sure to charge the battery fi rst. See below for more
details on charging the battery

INsErT MICrO sd CArd

To capture images with your microscope while NOT connected
to a computer, you need to insert a MicroSd card.
NOTE:
The MicroSD card is NOT included. To capture images without a MicroSD card,
see section 5.E in this manual for instructions on installing the computer software
and using it to save images to your computer.
locate the MicroSd card slot (2) on the side of the lCd
housing.
Slide the card into the slot until it clicks into place and latches.
Be sure not to force the card into the slot, as this may damage
the card or the slot.
NOTE: The MicroSD card should be formatted before use. See section 6.2.G for details
on formatting the card.
pOWEr ON
Press the POWeR button to turn the unit on.
Press POWeR button again to turn the unit off.
NOTE:
The Infi niView™ has a Power Save feature. Refer to section 6.2.C for details.
Power button
ENGLISH
5