Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-68-003.book Page 16 Monday, January 28, 2008 11:32 AM
16 | English
Hold the power tool only by the insulated
gripping surfaces when performing an oper-
ation where the cutting tool may contact
hidden wiring or its own cord. Contact with
a "live" wire will also make exposed metal
parts of the power tool "live" and shock the
operator.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The machine is intended for sawing wood, plas-
tic, metal and building materials while resting
firmly on the workpiece. It is suitable for
straight and curved cuts. When using the appro-
priate bimetal saw blades, it is possible to cut
flush to the workpiece surface. The saw blade
recommendations must be observed.
1 609 929 N64 | (28.1.08)
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Saw blade*
2 Adjustable footplate
3 SDS clamping lever for saw blade release
4 Clamping plate
5 Saw blade holder
6 Stroke rod
7 Rotating collar
8 Release button for the collar
9 Utility hook
10 On/Off switch
11 Soft grip
*The accessories illustrated or described are not in-
cluded as standard delivery.
Technical Data
Sabre saw
Article number
Rated power input
Stroke rate at no load n
0
Tool holder
Stroke rate control
Stroke
Cutting capacity, max.
– in wood
– in non-alloy steel
– Pipe diameter
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
GSA 900 E
Professional
3 601 F4C 0..
W
900
spm
0 – 2700
SDS
mm
28
mm
250
mm
20
mm
130
kg
3.3
/ II
Bosch Power Tools
Publicité
Table des Matières
