Philips YS534 Mode D'emploi page 11

Wet shaving
To achieve better shaving results you can also use this shaver on a wet
face with shaving foam or shaving gel.
To shave with shaving foam or shaving gel, follow the steps below:
1 Apply some water to your skin.
2 Apply shaving foam or shaving gel to your skin.
3 Rinse the shaving unit under the tap to ensure that the shaving unit
glides smoothly over your skin. (Fig. 10)
4 Press the on/off button to switch on the appliance.
5 Move the shaving unit over your skin. Make circular
movements (Fig. 9).
Rinse the shaving unit under the tap regularly to ensure that it continues to
glide smoothly over your skin.
6 Dry your face and thoroughly rinse the shaving unit with a
sufficient amount of water after every shave. Make sure you rinse
all foam or shaving gel off the shaving unit (see also chapter 9).
Beard styling (YS534 only)
- Only use this beard styler attachment to style facial hair. Do not use
this attachment to style body hair or scalp hair. The different
attachments of this appliance are designed for specific types of hair
and your facial hair differs from body hair or scalp hair (Fig. 11).
The appliance does not work from the mains for safety reasons.
attaching the beard styler attachment
1 Make sure the appliance is switched off.
2 Pull the shaving attachment straight off the appliance (Fig. 12).
Do not twist the shaving attachment while you pull it off the appliance.
EngliSh
11